$99.90
The was built from scratch to deliver our latest high-quality power module. The sensor is based on the ACS37800 power monitoring IC, which provides 0.85 mΩ primary conductor resistance for low power loss and high inrush current capabilities. It has excellent accuracy over the entire range.
 
The integrated capacitors reduce voltage noise, however we still recommend to install the included electrolytic capacitor to compensate for long battery wire lengths and motor noise.

NOTE: Control Zero w/ Aluminum enclosure and 'Stick' carrier board are not included!
 

Electrical:

  • 50.4V 12S LiPo
  • 60 Amps Continuous - 90 Amps Max Current Sensing
  • 5.3V, 3A power supply

Default Settings:

  • Set BATT_MONITORx to 8 (CAN)

Mechanical:

  • Board Weight: 5.90g (0.208 oz)
  • Board Dimensions:
    • 26mm x 26mm (1.02"x1.02")

Accesories included:

  • Molex ClikMate 2mm 6-pin to 2x JST-GH cable (6-pin PWR and 4-pin CAN)
  • JST-GH 4 to JST-GH 4 cable


Important! The module comes with pre-calibrated values, however end users are encouraged to verify and tune constants provided in the module's paramaters.
BATT_V_FINE_M and BATT_C_FINE_M are multipliers (1.0 default) to fine tune your power readings for your airframe. Keep a safe margin of battery capacity until calibrated and confirmed.

The measurements below are shipping related:

Current Stock:
SKU:
m10104
Availability
Usually Ships in 2 to 3 Weeks
Width:
4.00 (in)
Height:
6.00 (in)
Depth:
0.50 (in)
Power Module Options